SecureStart

Hardware wallet — quick setup & secure storage
Get started
Follow the steps below
Welcome! This page guides you step-by-step through setting up your hardware device so you can safely manage and protect your digital assets. The instructions are simple: connect, initialize, back up your recovery, and verify. Take your time and follow each step. This guide includes best practices to keep your backup secure and avoid common pitfalls.
1

Unbox & inspect

Remove the device from its packaging and check the tamper-evident seal (if present). Confirm the box and contents match the documentation. If anything looks suspicious, contact the vendor and do not proceed.

2

Connect to your computer

Use the supplied cable to plug the device into a trusted computer. Only connect to official or well-known setup portals. Never connect the device to a computer you do not control or that may be compromised.

3

Initialize & choose a PIN

Follow on-screen prompts to create a secure PIN. Choose a length and digits that you can remember but are not trivial. The device will lock if disconnected and will require the PIN to operate.

4

Write down your recovery

Write the recovery words precisely in the order shown. Use the physical recovery card supplied or a high-quality notebook kept in a secure place. Do not photograph, type, or store the phrase on an internet-connected device.

5

Verify & finalize

Confirm the recovery phrase on the device when prompted and run a quick test transaction with a small amount. Once verified, your device is ready to use.

Q — Where should I store my recovery?
A — In a physically secure location. Use a safe, a safety deposit box, or multiple geographically separated locations. Consider steel recovery plates for fire and water resistance.
Q — Can I share recovery words?
No. Never share recovery words. Anyone with your full recovery can access your funds without the device or PIN.